CipherLab 1562 User Manual download pdf (Page 9)

Inter record download delay:-

Before undertaking any data downloading activity the first bar code command to be sent

should be the inter record download delay instruction. This command will cause the 1560/62

BT to pause a commanded time between each set of data (bar code) downloaded and hence

give time for the receiving

program to process the data.

In order to send this instruction,

scan the command bar code

“Begin Instruction Mode” then

the command bar code for the

desired delay period (0.25 sec

is usually adequate) followed by

the “Finish Instruction Mode”

command bar code.

This download delay period

instruction sequence must be

sent prior to downloading data

and is required to be sent once

only, all subsequent data

download operations will use

the same delay period. See

Command bar codes 1, 2, 6

highlighted left.

Once the download delay has been set, the actual stored data can be downloaded to the

server, the targeted computer program should be prepared to receive the data.

In a similar fashion to the download delay instruction described above the data is downloaded

by firstly scanning the command bar code “Begin Instruction Mode” followed by the

command bar code “Transmit Stored Data” followed by the “Finish Instruction Mode”

command bar code. See command bar codes 1, 5, 6 highlighted below.

Downloading data:-

It should be noted that

immediately following the

instruction to download data the

1560/62 BT usually pauses a few

seconds before downloading

commences, this can lead to

concerns that the instruction has

not succeeded.

(Please wait).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

CipherLab 1562 User Manual Page 9