CipherLab 1661 Specifications download pdf (Page 65)

Update

In order to establish a proper connection between your computer and the scanner, we

suggest that you follow these instructions –

1) Install batteries and hold down the [Power/Delete] key for about 2 seconds to turn on

the scanner.

2) Have the scanner read the “Enter Setup” barcode to enter the configuration mode.

3) Have the scanner read the associated barcodes to activate the desired interface.

See the following sections for output interfaces supported.

4) Have the scanner read the barcodes for related settings.

5) Have the scanner read the “Update” barcode to exit the configuration mode.

6) Turn on your computer or laptop and establish a WPAN connection with the scanner.

Refer to

Chapter 3 – Setting up a WPAN Connection.

Note: (1) By default, the output interface is set to “BT HID”.

(2) For 1661, when it is set to Memory Mode and connected to computer via the

Direct USB cable, the default output interface becomes “Direct USB Virtual COM”.

IN THIS CHAPTER

2.1 BT HID..................................................................... 52

2.2 BT SPP Slave............................................................. 63

2.3 BT SPP Master........................................................... 65

2.4 USB HID via 3610...................................................... 69

2.5 USB Virtual COM via 3610........................................... 78

2.6 Direct USB HID (1661 Memory Mode Only).................... 80

2.7 Direct USB Virtual COM (1661 Memory Mode Only)......... 89

Chapter 2

SELECTING OUTPUT INTERFACE

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 234 235

No comments

CipherLab 1661 Specifications Page 65