CipherLab 1661 Specifications download pdf (Page 63)

Update

Chapter 1

Understanding the Barcode Scanner

1.14 HARDWARE RESET

1.14.1 RESTORE SYSTEM DEFAULTS

Instead of having the scanner read “Restore System Defaults” barcode, you may use key

combination, as described below, to restore system defaults during operation.

1) Hold down the [Power/Delete] key.

2) When the scanner responds with two short beeps (high tone), press the [Trigger] key

for about 5 seconds. The scanner LED indicator becomes solid red for a while and

then goes off.

3) When the scanner responds with a long beep (high tone), release the keys. Its LED

indicator becomes solid red and goes off quickly.

Note: The scanner will restart itself automatically.

1.14.2 RESET CONNECTION

When the output interface is BT HID or BT SPP Master, the scanner will attempt to

maintain an established connection. To stop such re-connection, you may need to have

the scanner read “Reset Connection” or “Restore System Defaults” barcode to clear the

current connection record. Alternatively, you may use key combination, as described

below, to reset connection during operation.

1) Hold down the [Trigger] key, and then press the [Power/Delete] key for at least 5

seconds.

2) The scanner will respond with two short beeps (high tone). Wait for a while until the

scanner responds with a long beep (high tone), release the keys.

Note: (1) After reset connection by hardware, the scanner will not restart itself

automatically. It will resume to its previous operation except no connection.

(2) For 1660, firmware version 1.34 or later is required.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 234 235

No comments

CipherLab 1661 Specifications Page 63