CipherLab 1562 User's Guide download pdf (Page 15)

Introduction

USING SCANMASTER

The ScanMaster is installed with a folder that contains two programs, ScanMaster.exe

and PrintBarcode.exe. They function for the configuration of the scanners. First, run

ScanMaster.exe on your computer. Select the model you are going to configure, and its

configuration can be done by (A) starting a new configuration, (B) opening an existing

configuration file, or (C) reading the configuration from a scanner. Then send the

configuration to other scanners directly, or generate a file named Barcode.prn to keep a

copy of the setup barcodes for the configuration.

Note: (1) When you choose to generate the setup barcodes, a file named Barcode.prn is

brought about inside the directory where the ScanMaster.exe and

PrintBarcode.exe co-exists. If you wish to keep the Barcode.prn file, you need to

rename it; otherwise it is overwritten each time a new set of setup barcodes is

generated again.

(2) The *.prn file is printable. Open a *.prn file with the PrintBarcode.exe.

Refer to Chapter 5

Applying Editing Formats

Refer to Chapter 4

Defining Output Format

Refer to Chapter 1

Changing Scanner Settings

Refer to Chapter 2

Selecting Output Interface

Refer to Chapter 3

Changing Symbology Settings

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 159 160

No comments

CipherLab 1562 User's Guide Page 15