CipherLab 1520 User's Guide download pdf (Page 27)

Chapter 2 Barcode Settings

2.2 RFID READER

By default, the RFID reader is enabled to read UID only. Click the button

to configure the associated settings.

2.2.1 DATA

Read UID

By default, the RFID reader is set to read tag UID (Unique Identification).

 UID: a permanent factory programmed unique identification (UID) code which is unique to

each tag.

Read Data

Select the check box so that RFID data can be read.

 If only partial data is required, specify the start position and maximum length.

Use Delimiter

Select the check box and specify a delimiter to separate UID from data when both are read.

 Click the editing box and select one character from the Grid Control (ASCII codes).

Delay before Re-read

By default, the RFID reader is set to re-read the same tag by an interval of 0.4 second when the

tag is not removed out of range.

 You may specify a delay time before re-read in the range of 1~9999, in units of 100

milliseconds.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 90 91

No comments

CipherLab 1520 User's Guide Page 27