CipherLab 1520 User's Guide download pdf (Page 75)

The tables below list reader settings as well as symbology settings for the 2D scan

engine.

READER SETTINGS TABLE

2D Engine Description Default

Scan Mode Laser mode

Continuous Mode Non-stop scanning

 To decode the same barcode repeatedly, move away the scan beam

and target it at the barcode for each scanning.

Test Mode Non-stop scanning

 Capable of decoding the same barcode repeatedly

Alternate Mode Press the scan trigger to start with scanning.

 The scanning won’t stop until you press the trigger again.

Aiming Mode Press the scan trigger to aim at a barcode. Within one second, press the

trigger again to decode the barcode.

 The scanning won’t stop until (a) a barcode is decoded, (b) the pre-set

timeout expires, or (c) you release the trigger.

Laser Mode Hold down the scan trigger to start with scanning.

 The scanning won’t stop until (a) a barcode is read, (b) the preset

timeout expires, or (c) you release the trigger.

Auto Off Mode Press the scan trigger to start with scanning.

 The scanning won’t stop until (a) a barcode is read or (b) the preset

timeout expires.

Focus Mode Select the focus mode to control the working range:

 Far Focus – optimized to read at its far position

 Near Focus – optimized to read at its near position

 Smart Focus –

toggles the focus position after every

frame

Far Focus

Decode Illumination Decide whether to flash illumination on every barcode

capture to aid decoding.

 Turn On (Internal LED)

 Turn Off

Aiming Pattern Decide whether to project the aiming

pattern during

barcode capture.

 Turn On

 Turn Off

Appendix IV

2D SCAN ENGINE

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 86 87

No comments

CipherLab 1520 User's Guide Page 75